NEW CUSTOM COLORS STICKERS!

13 colors

6 models

Infinite possibilities to custom your helmet!

How to:

INSTRUCTIONS: Clean the whole helmet thoroughly on the outer surface, then proceed with cleaning hands ensuring they are perfectly dry. In a clean place, apply the stickers as shown in the pictures: e.g. within a sticker set (see picture below the helmet), the individual sticker marked under number 2 must be applied in the position no.2 of the helmet (see helmet picture); in the same way, sticker no. 2 must be placed on position no.2 of the helmet, a.s.o. Handle the side with glue as little as possible!! Apply the sticker with care, avoiding pressing too much, starting from a corner and laying it little by little without bending it; in the event that bubbles appear under the film, unglue it until the bubble spot and try again attempting to lay it completely. When the sticker is completely applied, press with a firm hand to make sure the catching of glue is firm. It is recommended to heat the stickers by means of hot air (hairdryer at maximum temperature) for 2/3 seconds at 20cm/8in distance, then press again with fingers.